installed on the computer network card is usually connected and operating correctly.But in some cases it can be disabled in the BIOS or operating system settings.In this case, the network card should be included.
If you know that your computer has a network card, but the operating system does not see it, check the settings BIOS.Restart the computer during system startup, press Del or F2.To enter the BIOS may be used and other key - Esc, F1, F11, F12, depending on the computer model.
In the BIOS screen, find the section in which there is the word of Integrated.There look for a string Onboard LAN Controller or something similar in the sense - on different computers these lines may vary.
Look what value found exposed in front of the line.If Disabled, the card is really disabled.Select Enabled and save the changes, usually to do this, press F10 or select Save and exit setup.After the computer restarts, the operating system must see the network map .
possible that the NIC is disabled in the settings of the operating system.Open the "Start" - "Control Panel" - "System" - "Equipment" - "Device Manager".Find the item "Network Adapters."If the card is disabled, it will be marked with a red cross.To enable it, double-click it with the mouse and click at the bottom of the option "This equipment is used (included)."Click OK, the network card is enabled.Connect the connector to it and try to go on the Internet, everything should work.
It may happen that the line network card will be marked with a yellow icon with an exclamation point.Most likely, the network card drivers are not installed.Try to install them from the installation disk if it is, or find on the Internet.To reset again, double-click the mouse line network board, select the tab "Driver" - "Update".In the window that appears, select "Install from a list or specific location" and open the folder with the driver.Click OK, the drivers will be installed.
Tip 2: How to enable network drive
Connecting network drives allows you to place the evidence base in one place, allowing access only to a specific group of users.This greatly simplifies the task for network administrators regular backups of data and control activities within the network.
For any connection method you need to know the name of the server and the name of the resource to which you want to access.Find out this information from your network administrator.
Open "My Network Places" by the start button "Start".Further, "The whole network» - & gt;"Network Microsoft Windows».You will see a list of domains that are in the network.Select the desired double-clicking on its icon, open a new list - computers.Click the computer and select the drive or folder where you want to assign a name to a network drive.
Select from the context menu (by right-clicking) the command "Map Network Drive".Come up with a letter to the new drive and check "reconnect every time you log in" to setting was not lost after switching off the computer.Click "Finish" button, then open the contents of a new network drive.
Connect the drive is possible through the "Explorer".Open it via the "Start".In the Explorer menu, open the "Tools", then select "Map Network Drive".Come up with a letter and select it in the drop-down list.Traditionally, the letters X, Y or Z, but can select any of the currently available.
Enter the server name in the "Folder" after the double backslash, and then the name of the resource through a single slash as follows: \ imya_serveraimya_resursa, or use to select the "Browse" button.
There is a third way: to connect a network drive via the command "Run", which runs through the menu, the same button "Start".In the window in the "Open", type "cmd", enter the string "net use x: \ imya_serveraimya_resursa" and press Enter.In this recording x - letters assigned to the new drive.You will see the contents.
Keep in mind that including network drives can only share, iefolder or drive on another computer is configured properly.
- bios card