Laptop Keyboard is virtually no different from the keyboard, use a personal computer.The same key, the same key sequence, the same principle of fastening buttons on the base.You will unnecessarily be a computer expert to insert the key in the laptop, these actions are carried out simply enough.
- Laptop, button, clip.
before you consider the installation button on the notebook should talk about how to remove that same button.That is, the procedure for replacing the keys on a laptop will be considered from the outset.So, what should follow to replace the keys on a laptop keyboard.
Removing keys.If a standard PC keyboard, this operation takes place without complications (key just clasped on both sides and removed the heavy traffic at side), then when removing the key from the laptop, the user should be more careful.Here, it is likely that you damage one of the key bindings.In the future, this defect is fairly spoil your mood at work with a laptop.
To remove the key from the database, you need to proceed as follows.Find the clip and straighten it.Pass the clip under the bottom of the key, and then, pull it out.This should be done very carefully.In most cases, the key, and can be easily removed from the base.If you need to remove a few keys, perform the same operation on each of them.Note that before removing the buttons, you should write down their location on the sheet of paper.This will help you in the future to collect the keyboard properly.
Setting keys on a laptop does not require any of the care that was appropriate when removing buttons.However, you should be very careful.To install a button on the laptop, set it the correct location.Once the key will take its place, a slight touch of a finger press it down to the platform.The button will be fixed with plastic fasteners.
Tip 2: How to Insert key on the keyboard
Any keyboard is quite gentle and sensitive device.And that it most likely to occur all sorts of trouble - trapped particles of dirt and dust, crumbs, pet hair, ashes from cigarettes and spilled liquid - all of these factors often result in damage to the keyboard.Its relatively fragile key often do not stand up "meetings" with small children, pets or particularly powerful vacuum cleaner, and simply fall off.But to fix this trouble is not so difficult.
- - needle
Consider the key and determine the position of the back of the fiksatoraNa key are two types of fasteners.These are two latches and two slots under the "ears" retainer.With this cover lock keys attached to the keyboard .The retainer consists of two connected hinge middle parts.If you stayed in the key lock, you must remove it from there.Only then can the key be set in place.To remove the lock, take the key, unfasten the latch with one hand key and print "antennae" of the lock grooves on the other side.
Consider klaviaturuNa keyboard are three pin contacts, serving for fixing the keys.Make sure that they are not bent.If you see that the pins are deformed, carefully bend the them in the correct position.Do not apply too much force asPins are made of aluminum and can break.
Install retainer back on this klaviaturuDlya Get mount a large pin contact and, with light pressure, get a lock on the two small contact.
Take the key and slide the tabs lock into the grooves cover key .Make sure the latch got into the slots, and gently press the cover key to keyboard .After hearing a click, verify that the key is seated.
Big key , in addition to the plastic retainers are equipped with a balancing arm, which serves to provide a uniform pressing.To fix this lever on the keyboard there are two additional "tab".To install more keys, you must first make the ends of the lever in the "ears", and then start the bottom "antennae" lock into the slots and lightly press the button.
If you find that the lock appeared dismantled, you can fix it with a needle.Get the details in one side of the slot, and using a needle, fix the second side part.
- how to replace a button on a laptop