Many laptop owners use a portable device as a primary computer.But if you want to see the video, much more comfortable to use a large screen, for example, a modern TV set with a big diagonal.In order to make laptop conclusion to an external display , you need to have the correct connection cable, and make a slight change in the operating system installation.
- - connecting cable (HDMI or VGA).
Determine which cable to transmit the signal from the laptop to the screen you need.Depending on whether you have a new technology, there can be different versions outputs laptop .On laptops the past two years using HDMI-interface.The same method of signaling support flat screen TVs and many monitors are large.You can easily recognize it by the inscription HDMI and form similar to a conventional socket for flash drives.The difference lies in the width of the socket for the cable and the number of contacts.
If laptop and external display there this interface, locate t
he appropriate cable.He often meets with the set.Or you can buy it in any shop of computer and consumer electronics.In the case where one of the devices do not have HDMI, worth checking out another popular plug - VGA.It looks like a blue ground with two rows of holes, sometimes on the sides there is a place for the clamping screws.Verify again that not only laptop , but the display was the same interface.Then buy VGA-cable assembly "male to male", ie contact with needles at both ends.
Connect the laptop to an external display.To do this, connect the VGA cable or HDMI socket of your device.This should be done with the power off.This also applies to the laptop and the screen.After checking the reliability of the connector and socket contacts can include equipment to the network.
configure additional conclusion images on laptop .Right-click on an empty part of the desktop and select "Properties" for Windows XP.Then select the tab "Settings" and you will see the setup menu conclusion and pictures.For Windows 7 or Vista you need to click "Start" menu, open the "Control Panel" and click on the link "Appearance and Personalization".
Then click on the menu "Display", subparagraph "Setting screen" or "Connecting to an external display."Activate the "Find" button, the system does not conclusion ur schematic representation of the second screen.Then select the operating mode: the duplication of the same image on both displays or work only with an external display.
After selecting the message "Save used mode screen?".Confirm your decision, and then click OK to close the configuration window.