Tip 1: How to disperse the hard drive

information contained in a computer is usually stored on its hard drive.It is the "slow" element in the data exchange.Increase the speed of the computer can be "dispersed┬╗ Winchester .Of course, you can simply replace the old HDD modern and faster.But it is quite expensive way.There are ways to speed up the work of the existing disk subsystem computer.
you need
  • - utilities to optimize the HDD.
Guide
1
Disconnect AAM - Automatic Acoustic Management - to increase productivity and, consequently, the rate of HDD.Check the BIOS to in paragraph hard disk controller mode is set to Native IDE (not AHCI), a utility that Victoria was able to gain access to the drives.Change this setting if necessary, read the manual for the motherboard.
2
After exiting the BIOS and download the full PC boot and run Victoria.After Victoria prompts you to select a controller, press P. Find the desired HDD controllers brute force available and the choice of the one that is connected to the desired Winchester .Find the line AAM.It identifies the factory settings.Change the setting by pressing F5.Pay attention to the clues and remember that the value of 128 corresponds to the minimum speed Winchester a and 254 - maximum.
3
Add an optional memory module.Right-click on the icon "My Computer" from the context menu, the inscription "Properties" and open the "Advanced" tab.In the "Performance" click on the label "Settings" and change the existing value to the smallest file size.This is done in order to cut back on the number of appeals to the HDD.
4
If possible, increase the number of physical disks to use two or RAID5-array.By separating the read-write operation using such an array, you can increase the performance gains and ensure the reliability of storage.Please note that for the organization of such an array, you will need at least three drives.
5
Periodically defragment one or more disks.Click on the disc label, right-click, and in the properties of the disc, select the tab "Tools."Run the defragmentation.
6
Use the MHDD.Install and run it.Enter in the window AAM command key * D, to disable the AAM and get the best performance.

Tip 2: How to disperse ADSL

If you are using an internet connection through a channel ADSL, you probably want to increase the speed of data transmission.To optimize the speed of Internet access is necessary to use a set of measures relating to software configuration, and fault detection of mechanical equipment.
How to overclock ADSL
you need
  • Advanced System Care.
Guide
1
Start by checking the status of the devices with which your network is set up.If you are using an ADSL-modem, then connect it to a telephone line through a splitter.The use of this small device can significantly reduce interference and ensure high-quality work of the Internet channel.
How to overclock ADSL
2
Make sure there is no damage to the telephone cable.If you find multiple stranding and other improvised connections, replace the cable.Damaged cables can be recovered and used to connect a landline phone, but not ADSL-modem.
3
now start configuring the software.Reset the modem by pressing the appropriate button on the device.Reconfigure the network equipment.The presence of the bulk of the routing table, which is created during the modem, can negatively affect the quality of the network.
4
Optimize your computer.To do this, perform a complex purification system.Fix your registry errors using the program RegOrganaizer or CCleaner.Delete all temporary files created by web browsers and other programs.
5
Download site www.iobit.com utility Advanced System Care.Complete the installation of the program and run it.During installation, select DSL and specify the connection speed, ISP stated.Click the "Tools" and click on the icon "Internet Assistant".Select the option "Automatic configuration" and click "Next".
6
Locate the "connection speed", and move the slider to the desired mark.Click "Next" and wait for the program to configure the settings for the network.
Helpful Hint
To access the BIOS, press the Delete key when you turn on your PC.
Sources:
  • MHDD

Search

Related Posts

Categories