process of overclocking the CPU - the procedure is not so difficult as it might seem at first glance.In carrying out this task should follow some precautions and be very careful not to overdo it and not to "kill" the system board.
- Guide to the motherboard of the computer tool for analysis and test systems (eg Everest), thermal paste to the processor (may be required in some cases), a program for overclocking the CPU (in the case of software overclocking).
Before you proceed directly to the procedure of overclocking the processor , need to learn some technical documentation, namely the instructions that came with the motherboard.It is necessary to find in the BIOS, the relevant sections.
Then you should decide how their methods will be carried out the procedure.There are two ways - a program (by means of special programs designed for this purpose) and the hardware (the method of dispersal by standard means BIOS).Programmatically acceleration processor in this article will not be considered, because the programs usually are detailed instructions.
Before you start overclocking, check the condition of thermal paste on the CPU.If it has dried, it must be replaced.Then you need to clean the cooler and ensure the greatest possible flow of air into the system unit (for this removed one of the end caps).Then you need to go to the BIOS (this is done by pressing Del or F2 key during system boot).Now, in the BIOS you need to find a function that determines the frequency working memory, and set its minimum value (this is done to ensure that the process of overclocking the CPU not limited by memory).Being this function can be in sections that relate to disperse processor or acceleration and memory timings, in most cases, it is one of the given names: Advanced Chipset Features, or Memclock index value, or Advanced, or POWER BIOS Features, or SystemMemory Frequency, or Memory Frequency.
Then go to the menu Frequency / Voltage Control (POWER BIOS Features, or JumperFree Configuration, or? Guru Utility - Other variants of the name).It is necessary to find the item that determines the frequency FSB (the name of your options: CPU Host Frequency, or CPU / Clock Speed, or the External Clock).Once an item is found, it is necessary to gradually increase.Here it is necessary to show care and patience.With increasing evidence points do not need to increase them a lot, but a little bit.After each increase is necessary to save the settings (corresponding request when exiting the BIOS) and restart the computer.After that, you should use specific tools to check whether overclocked processor, and system stability.