During installation, a relatively old operating systems on mobile computers may have problems with the definition of hard drives.To correct these problems need to install additional drivers .
- - DVD-ROM;
- - Ultra ISO.
The best option - to include the necessary drivers in the scope of the installation files.To get started, visit the official website of the developers of your mobile computer.Find and download drivers for SATA-hard disk.Extract the files from the downloaded archive.
Now find the image of the installation disk with Windows XP.If you already have available a drive, then download and install the program Ultra ISO.With its help create a virtual image of the DVD-ROM.
With all of the same program, change the contents of the received image.Create it in the root directory of a folder.Use only letters when choosing a name for the directory.Copy into this folder the files needed to determine the hard disk during the installation of the operating sys
resulting edited image, record a new disc.To do this, use the ISO File Burning.Run it, select the DVD-ROM drive, select the recording speed.Click "File ISO» and select the edited ISO-image installation CD.
Click "Write ISO» and wait until the program will perform the necessary action.Now insert the resulting disc DVD-ROM drive in a mobile computer.Turn laptop and hold F8.
Select Internal DVD-Rom after the appearance of the window quickly change the boot device.After completion of the installation files of the message that the hard disks are not found.Press F2 or another specified key.Specify a folder on the disk to which you copied the drivers.
Wait for the installation of the selected files and determine the hard drive.Continue the installation of the operating system in regular mode.
Tip 2: How to put a hard disk SATA
During the installation of the hard disk service center will have to pay some money.In addition to drag with a system unit - employment is also not very pleasant.It is much easier to install a hard drive at home.Even if you have no idea about the architecture of a computer, you still able to cope with this task.Moreover, once having made such a procedure, you will gain the necessary experience and, if necessary, will be able to help others.
- - Computer;
- - SATA-cable;
- - HDD SATA.
Further actions will describe the procedure of installing the hard disk interface SATA, since it is such hard drives are the most common today.To start, you need to disconnect the computer from the power supply.Also, disconnect the other components.Then unscrew the screws and remove the system cover.For convenience, place the system unit on its side.
now carefully review the system board.You need to find a SATA-interface.There may be more.Near them, and it is written SATA.Very often, these connectors are located on the bottom right side of the motherboard.If you have a diagram of your motherboard, you can find them at first with it.When you look for them, insert the SATA-cable in this interface.
Then install the hard drive into a free slot of the system unit.Screw the hard drive to the computer.To do this, use the mounting screws that need to be packaged to the hard drive.If you do not, they can be purchased separately.
Once the hard drive is installed in the bay, connect the other end of the SATA-cable.Now you need to connect a hard disk power.Among the wires that come from the power supply must be a wire connector on the end of which it is written SATA.That's it and you need to connect to your hard drive.
Do not close the cover of the system unit.Connect the monitor and mouse.Turn on the computer.Wait for the operating system.After this, go to "My Computer."Now there should appear an additional hard drive.
If all went well, and the system will recognize the device, you can close the computer cover and connect the other devices.But if a new hard disk does not appear, it is likely that you do not completely insert one of the cords.It is recommended to double-check the contact again.
- how to put a sata
- how to install sata